cisco Catalyst 9300 — VTP Version 2

VTP Advertisements Each device in the VTP domain sends periodic global configuration advertisements from each trunk port to a reserved multicast address. Neighboring devices receive these advertisements and update their VTP and VLAN configurations as necessary. Because trunk ports send and receive VTP advertisements, you must ensure that at least one trunk port is configured on the switch stack and that this trunk port is connected to the trunk port of another switch. Otherwise, the switch cannot receive any VTP advertisements. VTP advertisements distribute this global domain information:

• VTP domain name • VTP configuration revision number • Update identity and update timestamp • MD5 digest VLAN configuration, including maximum transmission unit (MTU) size for each VLAN • Frame format VTP advertisements distribute this VLAN information for each configured VLAN: • VLAN IDs (including IEEE 802.1Q) • VLAN name • VLAN type • VLAN state • Additional VLAN configuration information specific to the VLAN type In VTP version 3, VTP advertisements also include the primary server ID, an instance number, and a start index. VTP Version 2 If you use VTP in your network, you must decide which version of VTP to use. By default, VTP operates in version 1.

VTP version 2 supports these features that are not supported in version 1: • Token Ring support—VTP version 2 supports Token Ring Bridge Relay Function (TrBRF) and Token Ring Concentrator Relay Function (TrCRF) VLANs. • Unrecognized Type-Length-Value (TLV) support—A VTP server or client propagates configuration changes to its other trunks, even for TLVs it is not able to parse. The unrecognized TLV is saved in NVRAM when the device is operating in VTP server mode. • Version-Dependent Transparent Mode—In VTP version 1, a VTP transparent device inspects VTP messages for the domain name and version and forwards a message only if the version and domain name match.

Although VTP version 2 supports only one domain, a VTP version 2 transparent device forwards a message only when the domain name matches. • Consistency Checks—In VTP version 2, VLAN consistency checks (such as VLAN names and values) are performed only when you enter new information through the CLI or SNMP. Consistency checks are Configuring VTP VTP Advertisements VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 4