cisco Catalyst 9300 — Restrictions for Voice VLANs

C H A P T E R 3 Configuring Voice VLANs Prerequisites for Voice VLANs, on page 37 Restrictions for Voice VLANs, on page 37 Information About Voice VLAN, on page 38 How to Configure Voice VLANs, on page 40 Monitoring Voice VLAN, on page 43 Where to Go Next, on page 43 Additional References, on page 44 Feature History for Voice VLAN, on page 44 Prerequisites for Voice VLANs The following are the prerequisites for voice VLANs: • Voice VLAN configuration is only supported on device access ports; voice VLAN configuration is not supported on trunk ports. Trunk ports can carry any number of voice VLANs, similar to regular VLANs. The configuration of voice VLANs is not supported on trunk ports.

Note • Before you enable voice VLAN, enable QoS on the device by entering the trust device cisco-phone interface configuration command. If you use the auto QoS feature, these settings are automatically configured. • You must enable CDP on the device port connected to the Cisco IP Phone to send the configuration to the phone. (CDP is globally enabled by default on all device interfaces.) Restrictions for Voice VLANs You cannot configure static secure MAC addresses in the voice VLAN. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 37