cisco Catalyst 9300 — Trunking Modes

C H A P T E R 4 Configuring VLAN Trunks Information About VLAN Trunks, on page 45 Prerequisites for VLAN Trunks, on page 48 Restrictions for VLAN Trunks, on page 48 How to Configure VLAN Trunks, on page 49 Where to Go Next, on page 61 Additional References, on page 61 Feature History for VLAN Tunks, on page 61 Information About VLAN Trunks The following sections provide information about VLAN Trunks: Trunking Overview A trunk is a point-to-point link between one or more Ethernet interfaces and another networking device such as a router or a controller. Ethernet trunks carry the traffic of multiple VLANs over a single link, and you can extend the VLANs across an entire network.

IEEE 802.1Q— Industry-standard trunking encapsulation is available on all Ethernet interfaces. Trunking Modes Ethernet trunk interfaces support different trunking modes. You can set an interface as trunking or nontrunking or to negotiate trunking with the neighboring interface. To autonegotiate trunking, the interfaces must be in the same VTP domain. Trunk negotiation is managed by the Dynamic Trunking Protocol (DTP), which is a Point-to-Point Protocol (PPP). However, some internetworking devices might forward DTP frames improperly, which could cause misconfigurations. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 45