cisco Catalyst 9300 — Configuring Load Sharing Using STP Path Cost

Configuring VLAN Trunks Configuring Load Sharing Using STP Path Cost Command or Action Purpose Device> enable Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode on Device A. Step 3 interface interface-id Example: Device(config)# interface gigabitethernet 1/0/1 Defines the interface to be configured as a trunk, and enters interface configuration mode. Step 4 switchport mode trunk Example: Device(config-if)# switchport mode trunk Configures the port as a trunk port. Step 5 exit Example: Device(config-if)# exit Returns to global configuration mode. Step 6 Repeat Steps 2 through 4 on a second interface in Device A or in Device A stack.

Step 7 end Example: Device(config)# end Returns to privileged EXEC mode. Step 8 show running-config Example: Device# show running-config Verifies your entries. In the display, make sure that the interfaces are configured as trunk ports. Step 9 show vlan Example: Device# show vlan When the trunk links come up, Device A receives the VTP information from the other devices. This command verifies that Device A has learned the VLAN configuration. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 59