Configuring a Layer 2 Interface as an Isolated Private VLAN Trunk Port To configure a Layer 2 interface as an isolated PVLAN trunk port, perform this task: Procedure Configuring Private VLANs Configuring a Layer 2 Interface as an Isolated Private VLAN Trunk Port Command or Action Purpose Step 6 end Example: Device(config)# end Returns to privileged EXEC mode. Step 7 show interfaces [interface-id] switchport Example: Device# show interfaces gigabitethernet1/0/2 switchport Verifies the configuration. Step 8 copy running-config startup config Example: Device# copy running-config startup-config Saves your entries in the device startup configuration file.
Command or Action Purpose Step 1 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 2 interface interface-id Example: Device(config)# interface gigabitethernet1/0/2 Enters interface configuration mode for the Layer 2 interface to be configured. Step 3 switchport mode private-vlan { host | promiscuous | trunk promiscuous | trunk [secondary]} Example: Device(config-if)# switchport mode Configures the Layer 2 interface as an isolated private VLAN trunk port. VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 82