The lengths of the data sets of the modulator and the modulated channels are completely independent. Channels are attached by the system in a predetermined order, as shown in Table 5-5. To attach a channel as a modulator, you set its attach bit to 1. If you set either the volume or period attach bits for a channel, that channel's audio output will be disabled; the channel will be attached to the next higher channel, as shown in Table 5-5. Because an attached channel always modulates the next higher numbered channel, you cannot attach channel 3. Writing a 1 into channel 3's modulate bits only disables its audio output. Table 5-5:
Channel Attachment for Modulation ADKCON REGISTER Bit Name Function 7 ATPER3 Use audio channel 3 to modulate nothing (disables audio output of channel 3) 6 ATPER2 Use audio channel 2 to modulate period of channel 3 5 ATPER1 Use audio channel 1 to modulate period of channel 2 4 ATPER0 Use audio channel 0 to modulate period of channel 1 3 ATVOL3 Use audio channel 3 to modulate nothing (disables audio output of channel 3) 2 ATVOL2 Use audio channel 2 to modulate volume of channel 3 1 ATVOL1 Use audio channel 1 to modulate volume of channel 2 0 ATVOL0 Use audio channel 0 to modulate volume of channel 1 - Audio Hardware 147 -