A sample for an equal-tempered scale typically represents one full cycle of a note. To avoid aliasing distortion with these samples you should use period values in the range 124-256 only. Periods from 124-256 correspond to playback rates in the range 14-28K samples per second which makes the most effective use of the Amiga's 7 kHz cut-off filter to prevent noise. To stay within this range you will need a different sample for each octave. If you cannot use a different sample for each octave, then you will have to adjust the period value over its full range 124-65536. This is easier for the programmer but can produce undesirable high-frequency noise in the resulting tone.
Read the section called "Aliasing Distortion" for more about this. The values in Table 5-7 were generated using the formula shown below. To calculate the tone generated with a given sample size and period use: Clock Constant 3579545 Frequency = -------------- = ------- = 880.8hz Sample Bytes*Period 16*Period The clock constant in an NTSC system is 3579545 ticks per second. In a PAL system, the clock constant is 3546895 ticks per second. Sample bytes is the number of bytes in one cycle of the waveform sample. (The clock constant is derived from dividing the system clock value by 2.
The value will vary when using an external system clock, such as a genlock.) Using the formula above you can generate the values needed for the even-tempered scale for any arbitrary sample. Table 5-8 gives a close approximation of a five octave even tempered-scale using five samples. The values were derived using the formula above. Notice that in each octave period values are the same but the sample size is halved. The samples listed represent a simple triangular wave form. - Audio Hardware 155 –