The 68000 uses only the even-numbered memory access cycles. The 68000 spends about half of a complete processor instruction time doing internal operations and the other half accessing memory. Therefore, the allocation of alternate memory cycles to the 68000 makes it appear to the 68000 that it has the memory all of the time, and it will run at full speed. Some 68000 instructions do not match perfectly with the allocation of even cycles and cause cycles to be missed. If cycles are missed, the 68000 must wait until its next available memory slot before continuing.
However, most instructions do not cause cycles to be missed, so the 68000 runs at full speed most of the time if there is no blitter DMA interference. Figure 6-10 illustrates the normal cycle of the 68000. NOTE The 68000 test-and-set instruction (TAS) should never be used in the Amiga; the indivisible read-modify-write cycle that is used only in this instruction will not fit into a DMA memory access slot. ------------------------------------------------------------- | | | | | | | | operation | access | | portion | portion | | | | | odd cycle, | even cycle | | assigned to | available to | | other devices | the 68000 | ------------------------------------------------------------- Figure 6-10:
Normal 68000 Cycle If the display contains four or fewer low-resolution bit-planes, the 68000 can be granted alternate memory cycles (if it is ready to ask for the cycle and is the highest priority item at the time). However, if there are more than four bit-planes, bit-plane DMA will begin to steal cycles from the 68000 during the display. During the display time for a six-bit-plane display (low resolution, 320 pixels wide), 160 time slots will be taken by bit-plane DMA for each horizontal line. As you can see from Figure 6-11, bit-plane DMA steals 50 percent of the open slots that the processor might have used if there were only four bit-planes displayed. - Blitter Hardware 191 -