Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

Bit 1, DSKBLK, indicates "disk block finished." It is used to indicate that the specified disk DMA task that you have requested has been completed. This bit generates a level 1 interrupt. More information about disk data transfer and interrupts may be found in Chapter 8, "Interface Hardware." SERIAL PORT INTERRUPTS The following serial interrupts are associated with the specified bits of the interrupt registers. Bit 11, RBF (for receive buffer full), specifies that the input buffer of the UART has data that is ready to read. This bit generates a level 5 interrupt.

Bit 0, TBE (for "transmit buffer empty"), specifies that the output buffer of the UART needs more data and data can now be written into this buffer. This bit generates a level 1 interrupt.

Hardware Exec Software priority Label priority Description 1 1 Software interrupt SOFTINT 2 Disk block complete DSKBLK 3 transmitter buffer empty TBE 2 4 external INT2 & CIAA PORTS 3 5 graphics coprocessor COPER 6 vertical blank interval VERTB 7 blitter finished BLIT 4 8 audio channel 2 AUD2 9 audio channel 0 AUD0 10 audio channel 3 AUD3 11 audio channel 1 AUD1 5 12 receiver buffer full RBF 13 disk sync pattern found DSKSYNC 6 14 external INT6 & CIAB EXTER 15 special (master enable) INTEN 7 -- non-maskable interrupt NMI Figure 7-4: Interrupt Priorities - 216 System Control Hardware -