Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

Table 7-6: Contents of DMA Register Bit Number Name Function 15 SET/CLR The set/reset control bit. See description of bit 15 under "Interrupts" above. 14 BBUSY Blitter busy status - read-only 13 BZERO Blitter zero status-read-only. Remains 1 if, during a blitter operation, the blitter output was always zero. 12, 11 Unassigned 10 BLTPRI Blitter priority. Also known as "blitter-nasty." When this is a 1, the blitter has full (instead of partial) priority over the 68000. 9 DMAEN DMA enable. This is a master DMA enable bit.

It enables the DMA for all of the channels at bits 8-0 8 BPLEN Bit-plane DMA enable 7 COPEN Coprocessor DMA enable 6 BLTEN Blitter DMA enable 5 SPREN Sprite DMA enable 4 DSKEN Disk DMA enable 3-0 AUDxEN Audio DMA enable for channels 3-0 (x = 3 - 0). For more information on using the DMA, see the following chapters: Copper Chapter 2 "Coprocessor Hardware" Bit-planes Chapter 3 "Playfield Hardware" Sprites Chapter 4 "Sprite Hardware" Audio Chapter 5 "Audio Hardware" Blitter Chapter 6 "Blitter Hardware" Disk Chapter 8 "Interface Hardware" - 218 System Control Hardware -