POTENTIOMETER SPECIFICATIONS The resistance of the potentiometers should be a linear taper. Based on the design of the integrating analog-to-digital converter used, the maximum resistance should be no more than 528K (470K +/- 10 percent is suggested) for either the X or Y pots. This is based on a charge capacitor of 0.047uf, +/- 10 percent, and a maximum time of 16.6 milliseconds for charge to full value, i.e. one video frame time. All potentiometers exhibit a certain amount of "jitter". For acceptable results on a wide base of configurations, several input readings will need to be averaged.
Port 1 connector ___________________ ________________________ \ o o o o o / | POT1Y | POT1X | POT1DAT \ o o o o / | COUNTER | COUNTER | DFF014 \__________/\_/ |____________|___________| Read only / \ | +5 / \ |\ | | / \______________| \____| / / | | | / Max=470k \ / | | |/ +/-10% /__/ __|__ | \ 47nf_____ |__________o______ / | _____|_ | \ \|/ | | | __|__ | V ^ | |__\ / OPEN /_\ | \ / | ^ V o____/ \ | | /___\ | KEY: | | | a= OUTRY | | | POTGO b= DATRY | o------| DFF034 c= OUTRX | | Write only d= DATRX __|_____|____________________________ e= OUTLY | | | | | | | | | | | f= DATLY | a | b |c |d |e |f |g |h |xxxxxx|i | g= OUTLX |____|____|__|__|__|__|__|__||||||||__| h= DATLX BIT 15 . . . .
BIT 0 i= START . . . . _______._____._____._____.___________ | | | | | | | | | | | 0 | RY |0 |RX|0 |LY|0 |LX| 0 | |____|____|__|__|__|__|__|__|_________| 14 POTINP POT COUNTER DFF016 Read only Figure 8-6: Potentiometer Charging Circuit - Interface Hardware 231 -