Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

A somewhat simplified method of determining the truth of the light pen value involves instructing the system software to read the register only during the internal vertical blanking period of 0 1. Read (long) VPOSR once, during the period of 0 2. Mask off the upper 15 bits of the 32-bit word and compare it with the hex value of $10500 (V=261). 3. If the VPOSR value is greater than $10500, the light pen has not triggered since the last top-of-screen. If the value is less, the light pen has triggered and the value read is the screen position of the light pen. Note that when the light pen latch is enabled, the VPOSR register may be latched at any time, and cannot be relied on as a counter.

This behavior may cause problems with software that attempts to derive timing based on VPOSR ticks. DIGITAL INPUT/OUTPUT ON THE CONTROLLER PORT The Amiga can read and interpret many different and nonstandard controllers. The control lines built into the POTGO register (address $DFF034) can redefine the functions of some of the controller port pins. Table 8-4 is the POTGO register bit description. POTGO ($DFF034) is the write-only address for the pot control register. POTINP ($DFF016) is the read-only address for the pot control register. The pot-control register controls a four-bit bidirectional VO port that shares the same four pins as the four pot inputs. Table 8-4:

POTGO ($DFF034) and POTINP ($DFF016) Registers Bit Number Name Function 15 OUTRY Output enable for bit 14 (l=output) 14 DATRY data for port 2, pin 9 13 OUTRX Output enable for bit 12 12 DATRX data for port 2, pin 5 11 OUTLY Output enable for bit 10 10 DATLY data for port 1, pin 9 (right mouse button) 09 OUTLX Output enable for bit 8 08 DATLX data for port 1, pin 5 (middle mouse button) 07-01 X chip revision identification number 00 START Start pots (dump capacitors, start counters) - 234 Interface Hardware -