Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

PARALLEL INPUT/OUTPUT INTERFACE The general-purpose bi-directional parallel interface is a 25-pin connector on the back panel of the computer. This connector is generally used for a parallel printer. For each data byte written to the parallel port register, the hardware automatically generates a pulse on the data ready pin. The acknowledge pulse from the parallel device is hooked up to an interrupt. For pin connections and timing, see Appendix E and F. SERIAL INTERFACE A 25-pin connector on the back panel of the computer serves as the general purpose serial interface. This connector can drive a wide range of different peripherals, including an external modem or a serial printer.

For pin connections, see Appendix E. INTRODUCTION TO SERIAL CIRCUITRY The Paula custom chip contains a Universal Asynchronous Receiver/Transmitter, or UART. This UART is programmable for any rate from 110 to over 1,000,000 bits per second. It can receive or send data with a programmable length of eight or nine bits. The UART implementation provides a high degree of software control. The UART is capable of detecting overrun errors, which occur when some other system sends in data faster than you remove it from the data-receive register. There are also status bits and interrupts for the conditions of receive buffer full and transmit buffer empty.

An additional status bit is provided that indicates "all bits have been shifted out". All of these topics are discussed below. SETTING THE BAUD RATE The rate of transmission (the baud rate) is controlled by the contents of the register named SERPER. Bits 14-0 of SERPER are the baud-rate divider bits. - 250 Interface Hardware -