Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

Table 8-9 shows the definitions of the various bit positions within SERDATR. Table 8-9: SERDATR / ADKCON Registers SERDATR Bit Number Name Function 15 OVRUN OVERRUN bit (Mirror - also appears in the interrupt request register.) Indicates that another byte of data was received before the previous byte was picked up by the processor. To prevent this condition, it is necessary to reset INTF_RBF (bit 11, receive-buffer-full) in INTREQ. 14 RBF READ BUFFER FULL (Mirror - also appears in the interrupt request register.) When this bit is 1, there is data ready to be picked up by the processor.

After reading the contents of this data register, you must reset the INTF_RBF bit in INTREQ to prevent an overrun. 13 TBE TRANSMIT BUFFER EMPTY (Not a mirror-interrupt occurs when the buffer becomes empty.) When bit 14 is a 1, the data in the output data register (SERDAT) has been transferred to the serial output shift register, so SERDAT is ready to accept another output word. This is also true when the buffer is empty. This bit is normally used for full-duplex operation. 12 TSRE TRANSMIT SHIFT REGISTER EMPTY When this bit is a 1, the output shift register has completed its task, all data has been transmitted, and the register is now idle.

If you stop writing data into the output register (SERDAT), then this bit will become a 1 after both the word currently in the shift register and the word placed into SERDAT have been transmitted. This bit is normally used for half-duplex operation. 11 RXD Direct read of RXD pin on Paula chip. 10 Not used at this time. 9 STP Stop bit if 9 data bits are specified for receive. - 252 Interface Hardware -