BLTDDAT Blitter destination data register This register holds the data resulting from each word of blitter operation until it is sent to a RAM destination. This is a dummy address and cannot be read by the micro. The transfer is automatic during blitter operation. BLTSIZE 058 W A Blitter start and size (window width, height) This register contains the width and height of the blitter operation (in line mode, width must = 2, height = line length). Writing to this register will start the blitter, and should be done last, after all pointers and control registers have been initialized.
BIT 15,19,13,12,11,10,09,08,07,06,05,04,03,02,01,00 --------------------------------------------------- h9 h8 h7 h6 h5 h4 h3 h2 h1 h0,w5 w4 w3 w2 w1 w0 h=height=vertical lines (10 bits=1024 lines max) w=width=horizontal pixels (6 bits=64 words=1024 pixels max) LINE DRAW BLTSIZE controls the line length and starts LINE DRAW the line draw when written to. The h field LINE DRAW controls the line length (10 bits gives LINE DRAW lines up to 1024 dots long). The w field LINE DRAW must be set to 02 for all line drawing. BLTxDAT 074 W A Blitter source x data register This register holds source x (x=A,B,C) data for use by the blitter.
It is normally loaded by the blitter DMA channel; however, it may also be preloaded by the microprocessor. LINE DRAW BLTADAT is used as an index register LINE DRAW and must be preloaded with 8000. LINE DRAW BLTBDAT is used for texture; it must LINE DRAW be preloaded with FF if no texture LINE DRAW (solid line) is desired. - Appendix A 263 -