Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

COPCON 02E W A Copper control register This is a 1-bit register that when set true, allows the Copper to access the blitter hardware. This bit is cleared by power-on reset, so that the Copper cannot access the blitter hardware. BIT NAME FUNCTION 01 CDANG Copper danger mode. Allows Copper access to blitter if true. COPINS 08C W A Copper instruction fetch identify This is a dummy address that is generated by the Copper whenever it is loading instructions into its own instruction register. This actually occurs every Copper cycle except for the second (IR2) cycle of the MOVE instruction. The three types of instructions are shown below. MOVE - Move immediate to destination.

WAIT - Wait until beam counter is equal to, or greater than. (keeps Copper off of bus until beam position has been reached). SKIP - Skip if beam counter is equal to or greater than (skips following MOVE instruction unless beam position has been reached). - 268 Appendix A -