Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

INTENA 09A W P Interrupt enable bits (clear or set bits) INTENAR 01C R P Interrupt enable bits (read) This register contains interrupt enable bits. The bit assignment for both the request and enable registers is given below. BIT# FUNCT LEVEL DESCRIPTION -------------------------------------------------------- 15 SET/CLR Set/clear control bit. Determines if bits written with a 1 get set or cleared. Bits written with a zero are always unchanged.

14 INTEN Master interrupt (enable only, no request) 13 EXTER 6 External interrupt 12 DSKSYN 5 Disk sync register (DSKSYNC) matches disk data 11 RBF 5 Serial port receive buffer full 10 AUD3 4 Audio channel 3 block finished 09 AUD2 4 Audio channel 2 block finished 08 AUDl 4 Audio channel 1 block finished 07 AUD0 4 Audio channel 0 block finished 06 BLIT 3 Blitter finished 05 VERTB 3 Start of vertical blank 04 COPER 3 Copper 03 PORTS 2 I/O ports and timers 02 SOFT 1 Reserved for software-initiated interrupt 01 DSKBLK 1 Disk block finished 00 TBE 1 Serial port transmit buffer empty INTREQ 09C W P Interrupt request bits (clear or set) INTREQR 01E R P Interrupt request bits (read) This register contains interrupt request bits (or flags).

These bits may be polled by the processor; if enabled by the bits listed in the next register, they may cause processor interrupts. Both a set and clear operation are required to load arbitrary data into this register. These status bits are not automatically reset when the interrupt is serviced, and must be reset when desired by writing to this address. The bit assignments are identical to the enable register below. - 274 Appendix A -