CHIP REGISTER MAP Each 8520 has 16 registers that you may read or write. Here is the list of register and the access addresses of each within the memory space dedicated to the 8520:
Register RS3 R52 RS1 RS0 (hex) NAME MEANING ------------------------------------------------------------ 0 0 0 0 0 pra Peripheral data register A 0 0 0 1 1 prb Peripheral data regigter B 0 0 1 0 2 ddra Data direction register A 0 0 1 1 3 ddrb Direction register B 0 1 0 0 4 talo Timer A low register 0 1 0 1 5 tahi Timer A high register 0 1 1 0 6 tblo Timer B low register 0 1 1 1 7 tbhi Timer B high register 1 0 0 0 8 todlow Event LSB 1 0 0 1 9 todmid Event 8-15 1 0 1 D A todhi Event S 1 0 1 1 B No connect 1 1 0 0 C sdr Serial data register 1 1 0 1 D icr Interrupt control register 1 1 1 0 E cra Control register A I 1 1 1 F crb Control register B SOFTWARE NOTE:
The operating system kernel has already allocated the use of several of the 8520 timers. CIAA, timer A - keyboard (used continuously to handshake keystrokes). NOT AVAILABLE. CIAA, timer B - Virtual timer device (used continuously whenever system Exec is in control; used for task switching, interrupts and timing). CIAA, TOD - 50/60 Hz timer used by timer.device. The A1000 uses power line tick. The A500 uses vertical sync. The A2000 has a jumper selection. CIAB, timer A - not used CIAB, timer B - not used CIAB, TOD - graphics.library video beam follower. This timer counts at the horizontal sync rate, and is used to synchronize graphics events to the video beam.
Note that previous editions of this chart were incorrect. - Appendix F 319 -