Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

o If bit 7 is a 1, then any bit 6-0 in your own mask byte which is set to a 1 sets the corresponding bit in the MASK register. Any bit that you have set to a 0 causes the MASK register bit to remain in its current state. o If bit 7 is a 0, then any bit 6-0 in your own mask byte which is set to a 1 clears the corresponding bit in the MASK register. Again, any 0 bit in your own mask byte causes no change in the contents of the corresponding MASK register bit. If an interrupt is to occur based on a particular condition, then that corresponding MASK bit must be a 1. Example:

Suppose you want to set the Timer A interrupt bit (enable the Timer A interrupt), but want to be sure that all other interrupts are cleared. Here is the sequence you can use:

INCLUDE "hardware/cia.i" XREF ciaa ; From amiga.lib lea ciaa,a0 ; Defined in amiga.lib move.b 401111110,ciaicr(a0) MSB is 0, means clear any bit whose value is 1 in the rest of the byte INCLUDE "hardware/cia.i" XREF ciaa ; From amiga.lib lea ciaa,a0 ; Defined in amiga.lib move.b %100000001,ciaicr(a0) MSB is 1, means set any bit whose value is 1 in the rest of the byte (do not change any values wherein the written value bit is a zero) READ INTERRUPT CONTROL REGISTER REG NAME D7 D6 D5 D4 D3 D2 D1 D0 --- ---- -- -- -- -- -- -- -- -- D ICR IR 0 0 FLG SP ALRM TB TA WRITE INTERRUPT CONTROL MASK REG NAME D7 D6 D5 D4 D3 D2 D1 D0 --- ---- -- -- -- -- -- -- -- -- D ICR S/C x x FLG SP ALRM TB TA - 326 Appendix F -