Commodore Amiga 1000 — Commodore Amiga 1000 Hardware Reference Manual PDF Download

OFFSET: Address 1 Address 2 Description (cont.) ------------------------------------------------------------------------- (S40/42) 7 6 5 4 3 2 1 0 Write Read R/W | | | | | | | | Not Inverted | | | | | | | \_ Interrupt enable Interrupt enable | | | | | | \____ User definable Undefined | | | | | \_______ Local reset Must be 0 | | | | \__________ User definable Undefined | | | \_____________ User definable INT2 pending | | \________________ User definable INT6 pending | \___________________ User definable INT7 pending \______________________ User definable Board pull INT NOTE Use of the S40/42 registers is an optional feature which can be implemented by boards which generate interrupts.

They make it possible for board-specific interrupt servers to determine if the current interrupt is being generated by their board, or by some other hardware using the same interrupt line. (S44/46) 7 6 5 4 3 2 1 0 Reserved, read must be 00 R/W Write undefined Inverted (S48/4A) 7 6 5 4 3 2 1 0 Base add. register, write only. Write Only \___ ___/ \___ ___/ These bits are compared with A23 Not Inverted \/ \/ through A16 (or fewer) to determine Hi nibble Lo nibble the base address of the board. ($4C/4E) 7 6 5 4 3 2 1 0 Optional shut-up register.

Write Only \___ ___/ \___ ___/ Any write to $4C will cause \/ \/ board to pass CONFIG-OUT and \_________________\ and then never respond again / to any address, until RESET. A bit in nibble $08 flags whether the board can be shut-up. (S50 through S7E) Reserved, must be 00 Inverted Remember that an nibbles except S00/02 and $40/42 will actually appear inverted from the values in the above Table. For example, a "must be 0" nibble will appear as $F, and flags and hex values will also be inverted (i.e. a value of $1 will read as $E, etc). - 340 Appendix G -