SPECIFYING AMOUNT OF DELAY The amount of delay in horizontal scrolling is controlled by bits 7-0 in BPLCON1. You set the delay separately for each playfield; bits 3-0 for playfield 1 (bit-planes 1, 3, and 5) and bits 7-4 for playfield 2 (bit-planes 2, 4, and 6). NOTE Always set all six bits, even if you have only one playfield. Set 3-0 and 7-4 to the same value if you are using only one playfield. The following example sets the horizontal scroll delay to 7 for both playfields. MOVE.W #$77,BPLCON1+CUSTOM SCROLLED PLAYFIELD SUMMARY The steps for defining a scrolled playfield are the same as those for defining the basic playfield, except for the following steps: o Defining the data fetch.
Fetch one extra word per horizontal line and start it 16 pixels before the normal (unscrolled) data-fetch start. o Defining the modulo. The modulo is two counts less than when there is no scrolling. These steps are added: o For vertical scrolling, reset the bit-plane pointers for the amount of the scrolling increment. Reset BPLxPTH and BPLxPTL during the vertical blanking interval. o For horizontal scrolling, specify the delay. Set bits 7-0 in BPLCON1 for 0 to 15 bits of delay. - 80 Playfield Hardware -