! \ Technical Reference A-23 X-X disable both this extra RAM and the real-time clock. J500 This jumper is used to enable the 512K of RAM at $C00000 and the real-time clock. It is normally closed; opening it will cost on internal drives. Leaving the jumper open prevents the Amiga from seeing the ID sequence. ty, it has to be implemented on the A2000 motherboard to save circuitry on board, but as it's not an industry standard capabili lets it determine the drive type. External floppies have this ID open to leave the second floppy out of the main unit box.
The X X Amiga expects an ID bit stream from each floppy drive; this J301 This jumper is closed to add a second internal floppy drive, I \ one of these clocks. section is used. The system will not operate properly without the alternate position, the vertical sync pulse from the video * u i \ CIA timer chip. In the normal position, the 50/60Hz TICK clock, based on AC line frequency, is used as a time base. In 2 3 1 This jumper determines the time base used for the 50/60Hz J300 H port 1. H 3 the light pen input will be the FIRE input of mouse/joystick mouse/joystick port 0.
With the jumper in the other position, 2 position shown, the light pen input will be the FIRE input of 1 This jumper is used to set the light-pen port number. In the J200 ly; this keeps the current board compatible with simple en hancements to the chip set. U ' requires the A23 signal for proper management of the memory at $C00000. Future Fat Agnus chips may map things different ("7 # I I other position, this bit is A19. The current Fat Agnus chip J101 This jumper determines the high-order address bit for Fat 3 2 1 Agnus. In its normal position, the high-order bit is A23; in its I \ List of 2000 Motherboard Jumpers r \