Commodore Amiga 4000 (A4000) — Commodore Amiga 4000 (A4000) User's Guide — Free Manual PDF Download

5-2 Installing an Expansion Board The daughterboard itself is attached to the motherboard with edge connectors. The Amiga will not work properly if the daughterboard is not in place. 5. Slide the expansion board into the slot as illustrated in Figure 5- 2. Make sure that the front edge of the board is in the proper grooved guide and that the edge connector(s) are aligned correctly. Press firmly, but do not use excessive force, to seat the edge connector(s) fully into the slot. Expansion boards are supported by a grooved guide in front, and held in by a screw that secures the rear mounting bracket of the board to the Amiga's chassis. A plate covers the rear access port of empty slots. 4.

Remove the rear cover plate of the slot into which you are installing the board. Save the screw to secure the board. You should also keep the plate in case you need it in the future. 3. Turn the Amiga so that the daughterboard is facing you. 6. Reinstall the cover plate screw to hold the board in place. 7. Connect any wires, ribbon cables, etc., that may need to be attached to the board, as the board manufacturer's manual specifies. Installing an Expansion Board 1. Remove the Amiga's cover as described in Chapter 3. 2. Set any jumpers on the board that must be adjusted. 9. Reconnect peripherals and power and test the board. To install an expansion board: 8. Replace the Amiga's cover.