6-4 Front Bay Installation 9. Connect the drives' power and ribbon cables. Be sure the orientation of both cables is correct. The pin 1 side of a ribbon cable has a colored stripe along the edge. The pin 1 end of a drive connector is usually indicated by a small "1" printed near it on the drive circuit board. The pin 1 end of the cable connector should be at the pin 1 end of the drive connector. The power connectors are shaped to prevent you from inserting them the wrong way. The installation of a second floppy drive may require the adjustment of a jumper on the motherboard. If the new drive is a standard double-density (880 KB) Amiga drive installed as DF1:, then the DF1:
Enable jumper must be changed. See Appendix D for the location and setting ofthisjumper. If the drive is a high capacity (1.76 MB) drive like DFO:, no adjustment is necessary. You also may need to adjust a jumper on the drive itself. This should be explained in the drive's installation manual. Drive DFO: is attached to the connector in the middle of the ribbon cable. Be sure that when you reconnect DFO:, you use this connector. Other Amiga models attach DFO: at the end of the floppy ribbon cable, after the small twist at the end. On the A4000, this end of the floppy cable is used for DF1:. hardware came with the new unit, install it according to the manufacturer's directions. 8.
Replace the bracket and drives in the main unit, and secure it with its two screws. 10. Change any jumpers as necessary. See "Notes on Floppy Drive Installation" below. 11. Remove the cover panel for the bay in which you installed the new drive from the inside of the faceplate. 14. Reassemble the Amiga, reconnect peripherals and power, then test the new device. Notes on Floppy Drive Installation 12. Reconnect the keylock and LED assembly. 13. Replace the faceplate on the chassis.