6-6 Rear Bay Installation 5. If you are installing a second IDE hard drive, set its drive unit jumper for unit 1 so that it does not conflict with the existing drive, unit O. Then set the unit 0 jumper(s) to indicate that there is a slave device present. Refer to the drive manufacturers' instructions for jumper configuration. 6. Slide the new unit into the bracket and secure it with screws through the side mounting holes. If any additional mounting hardware came with the new unit, install it according to the manufacturer's directions. 7. Replace the bracket and drive in the main unit, and secure it with its four screws. 8. Connect the drives' power and ribbon cables.
Be sure the orientation of ribbon cables is correct. Figure 6-4. Rear drive bay bracket removal , '