Chapter 1: Introduction Provides temperature monitoring LED Indicators and Drive Failure Alarm help minimize human errors 1.3.2 Proper SAS Cable Confi guration for the SES-2 The AOC-LPZCR2 Series:
(Low Profi le Skyhawk ZCR RAID Card) • Low profi le Form Factor (2.5" H x 7.0" W) (65.0 mm H x 178.0 mm W) • Intel's 80321 I/O Processor @ 600MHz built-in • 256 MB onboard ECC DDR memory • 1 amp@ 3.3V • RAID 0, RAID 1, RAID 5, RAID 10, RAID 50* and JBOD** supported (*See Notes 1 & 2 Below.) (a) SAS (-based on the AMI MG9071/9072 Firmware) • Supports I 2 C Interface • Downward compatible with SATA disk drives • Supports PCI-X up to 100 MHz in the green slot (*See Note3) (b) SCSI (-based on the Q-Logic GEM318/GEM359 Firmware) • Supports Q-Logic's GEM318 or GEM359 Firmware with I 2 C Interface • Supports PCI-X up to 100 MHz in the green slot (*See Note 3) Operating Systems supported * Windows 2000, Windows XP, and Windows 2003 * Linux:
SuSE 9.0, SuSE 9.1, SuSE 9.2, Red Hat 3.0 and Red Hat 4.0 * Upgradable in the future. (* Notes: Note 1: RAID 50 is available for SAS/SATA. Note 2: JBOD is available for SATA/SAS/SCSI. Note 3: Please install the ZCR card in the green slot.) 1-5 Enclosure Management For SES-2 to work properly, you will need to select the correct SAS cable for system. There are two kinds of SAS cables that support Sideband Signals: • Mini SAS 4i to 4 ports • Mini SAS 4i to Mini SAS 4i Please refer to the table below for proper cable confi guration:
C able Part # Type Length Example C BL-0097L-02 Mini SAS 4i to 4 ports 19.69” (50CM) X6DH3-G2 to CSE-SAS-743TQ C BL-0118L-02 Mini SAS 4i to 4 ports 9.06” (23CM) X6DH3-G2 to CSE-SAS-822TQ, 6024H-32 (R), 7044H-32 C BL-0119L-02 Mini SAS 4i to 4 ports 5.19” (13CM) X6DHR-3G2 to CSE-SAS-813TQ 6014H-32 , C BL-0108L-02 Mini SAS 4i to Mini SAS 4i 15.35” (39CM) X6DHP-3G2 to CSE-SAS-816A, 6014P-32 (R) 1.4 Product Features