AOC-SIMSO/SIMSO+ User's Guide 3. Network Basic Settings: This window allows you to configure basic settings for your network. 4. IP Auto Configuration: Click on the box to activate the selection menu and select a desired item from the list. The options are None, DHCP, and BOODP. 5. Preferred Host Name (DHCP only): Enter a Preferred Host Name in the box. 6. IP Address: Enter the IP Address for the remote host in the box. 7. Subnet Mask: Enter the net mask of the local network in the box. 8. Gateway IP Address: Enter the local network router's IP address in this box for the accessibility of the users that are not connected to the local network. 9. Primary DNS Server IP Address:
Enter the IP Address of the Primary Domain Name Server in the box. 10. Secondary DNS Server IP Address: Enter the IP Address of the Secondary Domain Name Server in the box. It will be used when the Primary DNS Server can not be contacted. 11. Network Miscellaneous Setting: This field allows the user to configure the fol lowing Network Miscellaneous settings as listed below: 12. Remote Console & HTTPS Port: Enter the port numbers the remote host and the HTTP server are listening. If a number is not entered in the box, the default value will be used. 13. HTTP Port: Enter the port number the HTTP server is listening. If a number is not entered in the box, the default value will be used. 14.
SSH Port: Enter the port number the SSH server is listening. If a number is not entered in the box, the default value will be used. 15. Bandwidth Limit: Enter the maximum bandwidth value for network interfacing. The value should be in Kbits per second. 16. Enable SSH Access: Click this box to enable SSH Access. 17. Disable Setup Protocol: Check this box to disable the function of Setup Proto col for the SIMLP card. 18. LAN Interface Setting: This field allows the user to configure the following LAN Interface settings as listed below: 19. LAN Interface Speed: Click on the arrow on the right to activate the selec tion menu and select a desired speed. The options are:
Auto-detect, 10 Mega bits per second or 100 Mega bits per second. If Auto-detect is selected, LAN Interface Speed will be set at the optimized speed based on the system configurations de tected by the OS. 19. LAN Interface Duplex Mode: Click on the arrow on the right to activate the se lection menu to select a desired LAN Interface Duplex Mode. The options are: Auto- detect, Half Duplex and Full Duplex. If Auto-detect is selected, the LAN Interface Duplex Mode will be set to the optimized setting based on the system configurations detected by the OS. 3-26