refer to the vehicle's service manual, or contact us with specific vehicle information (e.g., VIN). 3. Properly connect the scan tool to the DLC (See Figure 3.1.3). Figure 3.1.2 The cable connector is keyed and will only fit one way. ● If you cannot plug the cable in, please rotate the connecter 180° and try it again. Figure 3.1.3 4. Turn the ignition to the ON position (II) (See Figure 3.1.4), DO NOT start the engine. ● If your vehicle is equipped with a keyless start system and the ignition switch is an "engine start-stop" button (See Figure 3.1.5), press the ignition button until the car is in the "ON" Mode.
Do not press the brake while pressing the ignition button or you will start the car instead of putting it in the "ON" position. EN | 15