Delta Electronics — 5.2.6 Functions

AS Series Module Manual 5.2.6 Functions Use the HWCONFIG utility software built into ISPSoft to set modes of operation and parameters.  Analog input _5 1. Enable/Disable a Channel An analog signal is converted into a digital signal at a rate of 200 ms per channel. If a channel is not used, you can disable it to decrease the total conversion time. 2. Unit of Measurement Select the unit of measurement, Fahrenheit or Celsius, according to your needs. 5-14 Item Function Description 1 Enable/Disable a Channel 1. Enable or disable a channel. 2. If a channel is disabled, the total conversion time decreases. 2 Unit of Measurement Select the unit of measurement: Fahrenheit or Celsius.

3 Calibration Calibrate a linear curve. 4 Average Conversion values are averaged and filtered. 5 Disconnection Detection If the channel is open, the module can detect when it is disconnected. If the input is open-circuited, the module produces an alarm or a warning. 6 Channel Detection and Alarm If an input signal exceeds the range of inputs that the hardware can receive, the module produces an alarm or a warning. You can disable this function. 7 Limit Detections for Channels Save the maximum/minimum values for channels. 8 Records for Channels Save the analog curves for channels. 9 PID Algorithm PID control modes