AS Series Module Manual 5.2.4 Control Registers *If you use HWCONFIG to set values in CRs, once the set value is downloaded, the values can be retained in the module; however if you use TO instruction to write data into CRs, the values CANNOT be retained, after power failure or after transition of the CPU from STOP to RUN. Note: The attribute of the CR must be W (write) to use TO instruction. _5 5-8 CR# Name Description Atr. Defaults 0 Format Setup 0: integer format 1: floating point format R 0 1 Input channel 1 mode setup 0: closed 1: -10 V to +10 V (default) 2: 0–10 V 3: -5 to +5 V 4: 0–5 V 5: 1–5 V 6: 0–20 mA 7: 4–20 mA 8:
-20 mA to +20 mA R/W 1 2 Input channel 2 mode setup 3 Input channel 3 mode setup 4 Input channel 4 mode setup 5 Input channel 1 offset Range: -32768 to +32767 R/W 0 6 Input channel 2 offset 7 Input channel 3 offset 8 Input channel 4 offset 9 Input channel 1 gain Range: -32768 to +32767 R/W 1000 10 Input channel 2 gain 11 Input channel 3 gain 12 Input channel 4 gain 13 Input channel 1 average times Range: 1–100 R/W 10 14 Input channel 2 average times 15 Input channel 3 average times 16 Input channel 4 average times 17 Input channel 1 filter R/W 1