Delta Electronics — 7.2.4 AS04TC Control Registers

AS Series Module Manual 7.2.3 Arrangement of Terminals 7.2.4 AS04TC Control Registers *If you use HWCONFIG to set values in CRs, once the set value is downloaded, the values can be retained in the module; however if you use TO instruction to write data into CRs, the values CANNOT be retained, after power failure or after transition of the CPU from STOP to RUN. Note: The attribute of the CR must be W (write) to use TO instruction.

_7 7-6 AS04TC-A AS08TC-A 04TC I1 + PWR SLD I1- I2 + ERR A D SLD I2- I3 + SLD I3- I4 + SLD I4- 2 4V 0V 08TC I1+ I1- PWR I2+ I2- I3+ I3- ERR A D I4+ I4- I5+ I5- I6+ I6- I7+ I7- I8+ I8- SLD 24V 0V 04 SLD SLD TC I1 + PW I1- I2 + ERR A D I2- SLD SLD I3 + I3- I4 + I4- 2 4V 0V 08 I1+ I2+ I3+ I4+ TC I1- PW I2- I3- ERR A D I4- I5+ I6+ I7+ I8+ SLD I5- I6- I7- I8- 24V 0V CR# Name Description Atr. Defaults 0 Format Setup 0: integer format 1: floating point format R 0 1 Channel 1 mode setup 0: closed 1: -100 mV to +100 mV 2: J-Type 3: K-Type 4: R-Type 5: S-Type 6: T-Type 7: E-Type 8: N-Type 9: B-Type R/W 1 2 Channel 2 mode setup 3 Channel 3 mode setup 4 Channel 4 mode setup 5 Channel 1 offset Range:

-32768 to +32767 R/W 0 6 Channel 2 offset 7 Channel 3 offset