Delta Electronics — 11.1.2 Specifications

Chapter 11 DeviceNet Master Scanner Module AS01DNET-A 11.1 Introduction of AS01DNET-A  Thank you for choosing Delta AS01DNET-A. Please read this chapter carefully before use so as to ensure correct installation and operation of AS01DNET-A. 11  The instruction is simply a guideline for operation of the product and the details on the DeviceNet protocol is excluded here. Please refer to relevant articles and literatures for more details on the DeviceNet protocol.  AS01DNET-A, a DeviceNet network module can work in two modes: master /slave and RTU. The RTU- Master/Slave switch is used for selecting one of the two modes.

When AS01DNET-A works in master/slave mode, it makes up the DeviceNet master or slave with AS-series PLC together. When working in RTU mode, AS01DNET- A needs an external 24VDC power supply and can connect AS-series I/O modules onits right side. Refer to Section 11.4 and 11.5 for details about master/slave mode and RTU mode. 11.1.1 Feature  Supports the Group 2 server slave and Group 2 only servers.  Supports the explicit connection in the predefined master/slave connection and I/O polling connection.  Able to work as a DeviceNet master or slave as well as a remote RTU connecting AS series I/O modules.

 The network configuration software DeviceNet Builder offers the graphical configuration interface.  Supports the EDS file configuration in the DeviceNet network configruation tool. 11.1.2 Specifications  DeviceNet Connector  DeviceNet Communication  Electrical Specification 11-3 Item Specifications Transmission method CAN Electrical isolation DC500V Connector type Removable terminal block with screws (5.08mm) Communication cable 2 communication wires, 2 power wires and 1 shielded wire included. Item Specifications Message type I/O polling connection, explicit connection Baud rate Standard: 125 kbps, 250 kbps and 500 kbps Extension:

10 kbps, 20 kbps, 50 kbps, 125 kbps, 250 kbps, 500 kbps, 800kbps and 1M bps. Item Specifications Voltage The power wires of the communication cable provide 11 ~ 25 VDC. Current 28mA (typical value), 125mA impulse current (24 VDC)