Delta Electronics — 11.5.4.2.3. AS01DNET (RTU) Parameters Setup Page

Chapter 11 DeviceNet Master Scanner Module AS01DNET-A Double click AS01DNET (RTU) icon on the far left of the configuration page. Then the parameter setting interface of AS01DNET (RTU) comes out for setting the error handling method as follows. 11 Explanation of AS01DNET (RTU) parameter setup: 11-63 Item Description Default Output start address The start output address of AS01DNET (RTU), occupying one word. None Input start address The start input address of AS01DNET (RTU), occupying one word. None When loses DeviceNet connection AS01DNET (RTU)’s error handling method when AS01DNET (RTU) and DeviceNet master are disconnected. “RTU keep running” and “RTU stop” are for option.

RTU keep running When IO module error or no reply AS01DNET (RTU)’s error handling method when an error occurs in any one of I/O modules connected to the right side of AS01DNET (RTU). “RTU keep running” and “RTU stop” are for option. RTU keep running Software baud rate Chooses the extension baud rate of AS01DNET (RTU) after ticking the checkbox of it. The selected baud rate is stored in AS01DNET (RTU) after the download and it will not take effect until the hardware switch of AS01DNET (RTU): DR1 and DR0 are both ON. Refer to Section 11.2.6 for details on function switch. None Firmware version Displays the firmware version of AS01DNET (RTU). None