Chapter 13 IO-Link Communication Module AS04SIL 13.1 Overview Thank you for using the IO-Link master module AS04SIL-A. To ensure that your AS04SIL-A is installed and operated correctly, read this manual carefully before using the module. The AS04SIL-A module is an AS series IO-Link communication module (hereafter referred to as “SIL” module) connected together, they serve as a CAN remote device. SIL provides 4 channels, which can be separately configured in IO-Link on the right side of AS CPU module or AS00SCM-A (RTU mode). When the communication card AS-FCOPM is being used master or standard I/O (SIO) mode.
IO-Link master can freely connect with IO-Link devices and supports the hybrid use of IO-Link sensors and traditional sensors. Digital I/O of the SIL module can be extended with IO-Link hubs so that the sensors which do not support IO-Link can be connected to. Therefore it is pretty flexible to use the SIL module. software from Delta official website and installing it. The setup software for AS04SIL-A is HWCONFIG 4.0 which is built in ISPSoft.
You can use it after downloading the 13 13.1.1 Firmware and Software Versions 13-3 Firmware Model AS series CPU AS00SCM-A AS04SIL-A Version V1.08 and later V2.06 and later V1.00 and later Software Model ISPSoft HWCONFIG 4.0 AS00SCM-A CANopen EDS file Version V3.11 and later V4.03 and later V2.06 and later