Delta Electronics — 6.26.2 Explanation of High-speed Output Instructions

AS Series Programming Manual Drawing a clockwise arc 1. Define the four quadrants (QI, QII, QIII and QIV) of a coordinate system as in the graph below. Point A indicates the current coordinates on the X and Y axes. Y I II A X III IV 2. Point B is the target coordinates specified by S 1 and S 2 . Point O is the center of a circle enclosing both point A and point B. 3. For PLC with FW V1.04.59 or previous versions, S 3 is the distance to shift the center point O. For PLC with FW V1.04.60 or later, S 3 can also be the distance to shift the center point or central angle, if it is defined as the central angle, it is the included angle of AOB. 4.

The point A represents the origin of the axes X and Y in a plane. The target point B can be in Quadrant I, II, III, IV of the plane. Use the target point B to connect to the point A to draw a line and then use the setting values (shift the center point or central angle) in S 3 to define an arc travel path. _6 The figures below show 2 arc-travel path examples (solid lines) when the point B is in Quadrant I and IV with different setting values in S 3 (shift the center point). (r: radius) B S 3 >= 0 O B S 3 A r O r S 3 >= 0 S 3 A 6-848