AS Series Programming Manual DPPGB instruction is executed. When S 1 is 30,000 and S 2 is -30,000, the motion goes toward the target position A1=30,000. If the pulse position>15,000, the relative positions are modified into S 1 :20,000 and S 2 :-20,000, and the target position is momentarily A1=30,000. The target positions obtained through calculation are B1=10,000(A1+ S 2 ) and A2=30,000(B1+ S 1 ), since the outputting target positions cannot be modified. 3. S 3 is the target speed (must be a 32-bit integer), and S 4 is the target speed ratio adjusted value (must be a floating point number).
The actual speed is the result of multiplying the values in S 3 and S 4 and then rounding down the calculation result to a 32-bit integer. The acceptable input speed range is 1–200 kHz. When values are out of range, _6 the PLC automatically processes the value as the minimum or the maximum of the operation range. The ratio formula for the actual target speed is S 3 x S 4 . For instance, if target speed is 1 kHz, the adjusted floating point is 1.2345 and the actual value is 1234 Hz. 4. When the instruction is outputting, the target speed and the adjusted ratio can be modified, and the result is updated to the actual output speed once the instruction is scanned.
But it is suggested that you do not change the target speed too much in case the calculated deceleration is affected. 5. The output points for D 1 can only be Y0.0, Y0.2, Y0.4, Y0.6, Y0.8 and Y0.10, and it occupies 2 consecutive output points. The output sets and the output special register modes are listed in the following table. 6. D 2 is the flag indicating the target speed and the adjusted ratio that you can change. When this flag is ON, the executing target speed can be modified. When the flag switches from ON to OFF, it is now decelerating and the current target speed will be processes as the target speed for the next output.
6-880 Output axis number 1 2 3 4 5 6 D1+0 output points Y0.0 Y0.2 Y0.4 Y0.6 Y0.8 Y0.10 D1+1 output points Y0.1 Y0.3 Y0.5 Y0.7 Y0.9 Y0.11 Output modes SR462 SR482 SR502 SR522 SR542 SR562