Delta Electronics — 6.19.2 Explanation of Communication Instructions

AS Series Programming Manual 2. Master programming example Example 2 Slave Mode Using the CANRS instruction, the received data from the master are stored in the devices starting from D120 and the 8-byte data in D20~D27 are sent back. M110 changes to On when the sending and receiving are over. See the explanation of relevant parameters. 6-618 Slave mode MsgID=1 _ Communication mode 2= Slave mode, sends data after receiving data. Communication ID MsgID of the sent message, D0=2 Sent-data length 8 BYTE Starting device where D20 sent data are stored Starting device where received data are stored D120 for storing MsgID D121 for storing the number of received packets D122….

for storing received data Communication M110 completion flag Communication error flag M111 6