AS1010S-MR Server User & Service Manual PDF

AS1010S-MR USER’S MANUAL 1.0a

Page 1

The information in this User’s Manual has been carefully reviewed and is believed to be accurate. The vendor assumes no responsibility for any inaccuracies that may be contained in this document, makes no commitment to update or to keep current the information in this manual, or to notify any person or organization of the updates. The manufacturer reserves the right to make changes to the product described in this manual at any time and without notice. This product, including software, if any, and documentation may not, in whole or in part, be copied, photocopied, reproduced, translated or reduced to any medium or machine without prior written consent.

IN NO EVENT WILL THE MANUFACTURER BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR INABILITY TO USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN PARTICULAR, THE VENDOR SHALL NOT HAVE LIABILITY FOR ANY HARDWARE, SOFTWARE, OR DATA STORED OR USED WITH THE PRODUCT, INCLUDING THE COSTS OF REPAIRING, REPLACING, INTEGRATING, INSTALLING OR RECOVERING SUCH HARDWARE, SOFTWARE, OR DATA. Any disputes arising between manufacturer and customer shall be governed by the laws of Santa Clara County in the State of California, USA.

The State of California, County of Santa Clara shall be the exclusive venue for the resolution of any such disputes. The manufacturer's total liability for all claims will not exceed the price paid for the hardware product. Manual Revision 1.0a Release Date: April 3, 2006 Unless you request and receive written permission from the manufacturer, you may not copy any part of this document. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright © 2006 All rights reserved. Printed in the United States of America

Page 2

Preface Preface About This Manual This manual is written for professional system integrators and PC technicians. It provides information for the installation and use of the AS1010S-MR server. Instal- lation and maintainance should be performed by experienced technicians only. The AS1010S-MR is a high-end server based on the SC512C-260 1U rackmount chassis and the H8SSL-i, a single processor motherboard that supports AMD Op- teron processors and up to 4 GB of unbuffered ECC DDR400/333 SDRAM. Manual Organization Chapter 1:

Introduction The fi rst chapter provides a checklist of the main components included with the server system and describes the main features of the H8SSL-i motherboard and the SC512C-260 chassis, which comprise the 1010S-MR. Chapter 2: Server Installation This chapter describes the steps necessary to install the 1010S-8R into a rack and check out the server confi guration prior to powering up the system. If your server was ordered without processor and memory components, this chapter will refer you to the appropriate sections of the manual for their installation. Chapter 3:

System Interface Refer here for details on the system interface, which includes the functions and information provided by the control panel on the chassis as well as other LEDs located throughout the system. iii

Page 3

AS1010S-MR User's Manual Chapter 4: System Safety You should thoroughly familiarize yourself with this chapter for a general overview of safety precautions that should be followed when installing and servicing the 1010S-MR. Chapter 5: Advanced Motherboard Setup Chapter 5 provides detailed information on the H8SSL-i motherboard, including the locations and functions of connections, headers and jumpers. Refer to this chapter when adding or removing processors or main memory and when reconfi guring the motherboard. Chapter 6: Advanced Chassis Setup Refer to Chapter 6 for detailed information on the SC512C-260 server chassis.

You should follow the procedures given in this chapter when installing, removing or reconfi guring SATA or peripheral drives and when replacing the system power supply and cooling fan. Chapter 7: BIOS The BIOS chapter includes an introduction to BIOS and provides detailed informa- tion on running the CMOS Setup Utility. Appendix A: BIOS Error Beep Codes Appendix B: BIOS POST Checkpoint Codes Appendix C: System Specifi cations iv

Page 4