Chapter 5: Advanced Serverboard Setup Support The H8QMi-2+ supports single or dual-channel, registered ECC DDR2-667/533/400 SDRAM. Both interleaved and non-interleaved memory are supported, so you may populate any number of DIMM slots (see note on previous page). Populating two adjacent slots at a time with memory modules of the same size and type will result in inter- leaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory. Optimizing memory performance It is better to spread pairs of DIMMs across all memory banks with a CPU installed than to fi ll up one CPU memory bank while leaving another empty.
For example, if you were to install eight DIMMs in a quad-CPU confi guration, you should install two in the CPU1 DIMM slots (slots 1A and 1B) , two in the CPU2 DIMM slots, two in the CPU3 DIMM slots and two in the CPU4 DIMM slots rather than four in any two CPU DIMM slots. If you install four more, install two in the remaining CPU1 DIMM slots and two in the the remaining CPU2 DIMM slots, etc. This balances the load over all CPUs to optimize performance. In a single or dual-CPU confi guration, memory can only be installed in the banks associated with CPU#1 or CPU#1 and CPU#2, respectively. Maximum memory : 128 GB of DDR2-667/533/400. (Dual-CPU confi guration:
64 GB maximum, single-CPU confi guration: 32 GB maximum.) Figure 5-3. Installing DIMM into Slot Notch Notch To Install: Insert module vertically and press down until it snaps into place. The release tabs should close - if they do not you should close them yourself. Release Tab Release Tab Note: Notch should align with its receptive point on the slot Note the notch in the slot and on the bottom of the DIMM. These prevent the DIMM from being installed incorrectly. To Remove: Use your thumbs to gently push each re- lease tab outward to release the DIMM from the slot. 5-7