Super Micro Computer, Inc. 1041M-T2+ — Super Micro 1041M-T2+ User Manual: Comprehensive Guide for System Integrators

Chapter 6: Advanced Chassis Setup With the chassis cover removed, unplug the power and data cables from the 4. drive you want to remove. Locate the locking tab at the rear of the drive. (It will be on the left side of the 5. drive when viewed from the front of the chassis.) Pull the tab away from the drive and push the drive unit out the front of the chassis. Add a new drive by following this procedure in reverse order. You may hear a 6. faint *click* of the locking tab when the drive is fully inserted. Remember to reconnect the data and power cables to the drive before replac- 7. ing the chassis cover and restoring power to the system. Please be aware of the following:

The fl oppy disk drive cable has seven twisted wires. A color mark on a cable typically designates the location of pin 1. A single fl oppy disk drive ribbon cable has 34 wires and two connectors to provide for two fl oppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B. 6-5 Power Supply The SuperServer 1041M-T2+ has a single 1000 watt power supply, which is auto-switching capable. This enables it to automatically sense and operate at a 100v to 240v input voltage. An amber light will be illuminated on the power supply when the power is off.

An illuminated green light indicates that the power supply is operating. Power Supply Failure If the power supply unit fails, the system will shut down and you will need to replace the unit. Replacement units can be ordered directly from Supermicro (see contact information in the Preface). As there is only one power supply unit in the 1041M-T2+, power must be completely removed from the server before removing and replacing the power supply unit for whatever reason. 6-7