Delta Electronics — 3.5.2 Wiring for the CANopen communication connector

Wiring ASDA-B3 Connecting multiple servo drives: 3 Controller (1) 1 2 3 4 5 6 7 8 120 Ω (2) (1) Connect to the controller / PLC; (2) Wiring for CAN terminal resistor Note: 1. The CANopen cable length can be up to 30 m (98.43 ft). The communication quality and the number of connectable axes are determined by the controller’s specifications, quality of wires, grounding, interference, and whether a shielded twisted-pair cable is used. 2. It is suggested to use a terminal resistor of 120 Ω (Ohm) and 0.5 W (or above). 3. To connect multiple servo drives in parallel, use two sets of CAN ports as shown above, and put the terminal resistor in the last servo drive. 3-62