Delta Electronics — 3.10.8 EtherCAT communication mode

ASDA-B3 Wiring 3.10.8 EtherCAT communication mode Servo drive ASDA-B3-E Series 3 24V Note: 1. Refer to Section 3.3.7 for CN1 wiring. 2. Models of 200 W and below have no built-in brake resistor. 3. The brake coil has no polarity. 4. Connects to Mini USB (for PC communication). 5. Models of 1.5 kW and below can use single-phase power supply.

3-83 MCCB MC AC 200 / 230 V hree-phase*5 50 / 60 Hz COM+ _ DI1 NL DI2 PL DI3 EMGS DI4 DO1+ SRDY 1.5 kΩ DO1- DO2+ ALRM 1.5 kΩ DO2- A-phase OA differential signal /OA B-phase OB der utput differential signal /OB Z-phase OZ differential signal /OZ P R D S C T U V L1C W L2C CN2 1 CN1 2 5 * 1 3 6 4.7 kΩ 4 7 4.7 kΩ 5 8 4.7 kΩ 6 9 4.7 kΩ Case 15 16 CN4 17 18 1 2 11 CN6 12 CN 3 4 CN * 2 Regenerative resistor Red Power White supply Black Green 24VBRKR EMGS Brake * 3 Encoder +5V GND Do not connect this pin Do not connect this pin T+ SG Twisted-pair or T- twisted-shielded cable Shield Mini USB * 4 EtherCAT Connects to the controller 6A or previous servo drive Connects to the next servo 6B drive or no connection 1 +5V 2 GND 3 4 5 Do not connect this pin Do not connect this pin T+ COM+ DI1 DI2 5 6 7 _ NL DI3 DI4 DO1+ DO1- 8 9 15 16 DO2+ DO2- 17 18 OA 1 /OA 2 OB 11 /OB 12 OZ 3 /OZ 4 CN 6A CN 6B