Delta Electronics — CH05 Tuning

5 Tuning This chapter contains information about the auto tuning procedure and the three gain adjustment modes. Advanced users can also tune the servo system using the manual mode.

5.1 Tuning procedure and the applied mode ················································· 5-2 5.1.1 Flowchart of the tuning procedure ··················································· 5-2 5.1.2 Differences between gain adjustment modes ····································· 5-3 5.2 Auto tuning ······················································································· 5-4 5.2.1 Flowchart of auto tuning ································································ 5-5 5.2.2 Auto tuning with the drive panel ······················································ 5-6 5.2.3 Auto tuning with ASDA-Soft (software) ············································· 5-7 5.2.4 Alarms related to auto tuning ······················································· 5-14 5.3 Gain adjustment modes ···································································· 5-15 5.3.1 Flowchart of Gain adjustment mode ··············································· 5-15 5.3.2 Gain adjustment mode 1 ····························································· 5-16 5.3.3 Gain adjustment mode 2 ····························································· 5-16 5.3.4 Gain adjustment mode 3 ····························································· 5-17 5.3.5 Setting the bandwidth response level (stiffness) ······························· 5-18 5.3.6 Setting the command response gain (response) ······························· 5-19 5.4 Tuning in manual mode ····································································· 5-20 5.5 Mechanical resonance suppression ····················································· 5-22 5-1