Delta Electronics — 5.2.3 Auto tuning with ASDA-Soft (software)

ASDA-B3 Tuning Step 2: Click Controller: Motion Command from Controller and make sure the motion / machining path is set correctly. 5 Suggestions: set the motor to operate at least one cycle in both positive and negative directions. The delay time for reaching the positions in both positive and negative directions should not be less than 1,000 ms with the running speed no less than 500 rpm. Step 3: Repeatedly run the motor with the path you just set. Before running the motor, make sure no one is standing close to the machinery. Then, click Next . 5-9