ASDA-B3 Motion Control In the ASDA-Soft software, when you select the PR to be edited in PR mode, the corresponding parameters appear at the top of the window. See Figure 7.1.2. If you select PR#1, P6.002 and P6.003 appear at the top in the editing section. See P6.002 and P6.003 in Table 7.1.1 for example. The PR property and its data content differ in accordance with the motion command 7 type. For more information about Motion Control mode, refer to Section 7.1.3. Figure 7.1.2 PR Mode interface in ASDA-Soft Table 7.1.1 Example of PR#1 property and data content Note: TYPE: Control command mode 1 SPEED: speed control 2 SINGLE: positioning control; stop once positioning is complete. 3 AUTO:
positioning control; execute the next PR path once positioning is complete. 7 JUMP: jump to the specified path. 8 WRITE: write parameters to the specified path. 0xA INDEX: index positioning control 7-3 BIT 31 - 28 27 - 24 23 - 20 19 - 16 15 - 12 11 - 8 7 - 4 3 - 0 PR#1 P6.002 - AUTO DLY SPD DEC ACC OPT P6.003 TYPE No. Command mode