ASDA-B3 Installation 2.6.1 EMI filters All electronic equipment (including servo drives) generate high or low frequency noise during operation, which interferes with peripheral equipment through conduction or radiation. With an 2 EMI filter correctly installed, you can eliminate much of the interference. For better performance, it is recommended to use Delta’s EMI filter for suppressing the interference. Note: in the servo drive model column, 1 represents the product series and 2 represents the model code. The above table includes the B3, B3A, and B3B series.
General precautions for installation To ensure the best performance of the EMI filter, apart from the instruction and wiring of the servo drive, refer to these precautions: 1. The servo drive and EMI filter must be mounted on the same metal plate. 2. The wiring should be as short as possible. 3. The metal plate must be well grounded. 4. It is recommended to install one servo drive with one EMI filter. For more mounting specifications, refer to the following documents: 1. EN61000-6-4 (2001) 2. EN61800-3 (2004) PDS of category C2 3.
EN55011+A2 (2007) Class A Group 1 2-15 Recommended EMI filter Power Servo drive model 1PH 3PH 100 W ASD-B3 1 -0121- 2 EMF023A21A EMF10AM23A 200 W ASD-B3 1 -0221- 2 EMF023A21A EMF10AM23A 400 W ASD-B3 1 -0421- 2 EMF023A21A EMF10AM23A 750 W ASD-B3 1 -0721- 2 EMF023A21A EMF10AM23A 1000 W ASD-B3 1 -1021- 2 EMF023A21A EMF10AM23A 1500 W ASD-B3 1 -1521- 2 EMF023A21A EMF10AM23A 2000 W ASD-B3 1 -2023- 2 - EMF021A23A 3000 W ASD-B3 1 -3023- 2 - EMF021A23A