Delta Electronics — 9.1 RS-485 communication interface (hardware)

MODBUS Communication ASDA-B3 9.1 RS-485 communication interface (hardware) The ASDA-B3 series servo drive supports RS-485 serial communication that you can use to 9 access and change the parameters of the servo system. See the following description of the wiring: Note: 1. The cable length can be up to 100 meters when the servo drive is installed in a quiet environment. If the required transmission speed is over 38,400 bps, a 15-meter cable is recommended to ensure data transmission accuracy. 2. The numbers 4 and 5 in the above figure represent the pin number of each connector. 3. Use 12 V DC for the power supply. 4. When using RS-485 communication, you may connect up to 32 servo drives.

Install a repeater to connect more servo drives (the maximum is 127 stations). 5. Refer to Wiring for the CN3 communication connector in Chapter 3. 9-2