Absolute System ASDA-B3 Note A complete absolute servo system includes an ASDA-B3 servo drive, an absolute motor, and a 10 backup battery box. The backup battery supplies power to the system so that the encoder continues to operate even when the power is off. In addition, the absolute encoder can continuously record the motor’s actual position at any time, even when the motor shaft is rotated after the power is off. The absolute servo system must be used only with an absolute motor. If the servo is set up with other types of motors and the system is enabled, AL069 occurs. When using an absolute motor connected to power, the motor speed should not exceed 250 rpm.
When operating with the battery, make sure the maximum speed does not exceed 200 rpm. To determine whether your motor is an absolute type, check the model name as shown in the following: ECM-A3 series servo motor ECM – A3 – A / Y: absolute motor ECM-B3 series servo motor ECM – B3 – A / P: absolute motor ECMC series servo motor ECMC - W W / V: absolute motor Install the battery correctly on the encoder. One servo drive uses one single battery box; two servo drives can share one dual battery box. Use Delta’s encoder cable to connect to the battery box. See the following sections for the specifications of the battery box and its accessories. 10-2