Delta Electronics — 11.3.4 Profile Velocity Mode

CANopen Mode ASDA-B3 11.3.4 Profile Velocity Mode In PV (Profile Velocity) mode, the controller specifies the speed command and acceleration / 11 deceleration conditions, and the motion command generator of the servo drive plans the motion path according to these conditions. Max torque (6072h) Filter P1.006 P1.036 Velocity demand value Speed control Torque control (606Bh) loop loop Servo motor Torque actual value (6077h) M Velocity window (606Dh) Encoder Velocity window time (606Eh) Statusword Bit 10 Target reached (6041h) window comparator Position Speed comparator + - Velocity actual value (606Ch) Operation steps: 1. Set OD 6060h to 03h to set the mode as the speed control mode. 2.

Set OD 6083h for the acceleration time slope. 3. Set OD 6084h for the deceleration time slope. 4. Set the target speed (OD 60FFh) to 0. In speed mode, the servo motor starts operating once it is switched to servo on (Step 5). Therefore, setting the target speed (OD 60FFh) to 0 is to ensure that the motor maintains at 0 rpm at the time of servo on. 5. Set OD 6040h for the control command. Follow these steps. Steps 5.1 and 5.2 are to bring the servo drive's state machine into the ready state. For more details of the state machine, refer to Section 11.2.2.6. 6. Set OD 60FFh for the target speed.

11-26 Target velocity (60FFh) Speed command and limit function [RPM] Trajectory generator Max profile velocity (607Fh) E-Gear ratio 6093h sub2 6093h sub1 Step Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Description 5.1 0 0 1 1 0 Shutdown. 5.2 0 0 1 1 1 Switch on (ready for servo on). 5.3 0 1 1 1 1 Enable operation (servo on).