CHAPTER 1 — SET-Up & AREA 51 OPERATOR’S MANUAL Operating the Game To operate your game for maximum income, you should regularly run the self-test and check the controls with the Control Test and Sound Test in the self-test. By using the self-test regularly, you can find and fix problems immediately. This lets you keep your game in top condition. Inspecting the Game Characteristic Specification Input Current 3 Amps at 120 V Line Voltage 102 to 132 VAC Temperature 5° to 38° C (37° to 100° F) Humidity Not to exceed 95% relative Width 29.25 inches (75 Depth 34 inches (87 cm) Height 72 inches (183 cm) Weight 325 Ibs.
(148 kg) WARNING To avoid electrical shock, Table 1-1 the cabinet until it has been properly inyour area. This cabinet should be connected to a grounded threewire outlet only. If you have only two-wire outlets, we recommend that you hire a licensed electrician to install grounded outlets. Players can receive an electrical shock if the cabinet is not properly grounded. Make note of the power consumption when you set up this game, so that you do not overload your electrical circuit. See Table 1-1 for the power consumption and the other important specifications of this game. Inspect your Area 51 game carefully to ensure that the game is complete and was delivered to you in good condition.
Inspect the cabinet as follows: 2. Examine parts. the exterior for dents, chips, or broken Unlock and open the rear access door. Unlock and open the coin doors. Inspect the interior of the cabinet as follows: a. 1-2 Game Specifications do not plug in spected and set up for the line voltage in 1. cm) Check that all plug-in connectors on the cabinet harnesses are firmly plugged in. Do not force connectors together. The connectors are keyed so they fit only in the proper orientation. A reversed connector can damage a printed-circuit board (PCB). This will void your warranty. b. Ensure that all plug-in integrated circuits on each PCB are firmly plugged into their sockets. c.
Inspect the power cord for any cuts or dents in the insulation. d. Inspect the power supply. Check that the harness is plugged in correctly. Check that the green ground wires are connected. e. Inspect other sub-assemblies, such as the video displays, controls, printed-circuit boards, and speaker. Make sure that they are mounted securely and that the ground wires are connected. Control and Switch Locations All of the controls are located on the back of the cabinet or behind the coin doors. The following describes the locations in more detail: Power On/Off Switch The power on/off switch is located near the bottom of the rear door.
Volume Control There is no volume adjustment knob on any PCB in this game. Instead, volume is adjusted in the self-test software. The attract-mode and game-play volumes can be adjusted separately. Refer to Chapter 2 of this manual for more information. Self-Test Switch To perform the self test, open the upper coin door and activate the self-test switch mounted on a bracket located on the inside panel of the game cabinet. Coin Counter The coin counter is located below the lower coin door. the coin box, inside |